Compared with other accessories, the tire can be said to be one of the most easily worn and seriously worn parts of the automatic charging mixer. Because the performance of the tire will directly affect the normal use and comprehensive benefits of the operation of the full-automatic charging mixer, once the tire is damaged, it needs to be repaired in time. The following is my company's technical personnel to give you a simple explanation under the full-automatic feeding mixer tire damage when the correct treatment.
In terms of high temperature, it is easy to say that when the tire is scratched by high temperature, it is easy to say that when the tire is scratched by high temperature, it is not easy to say that when the tire is scratched by high temperature. Nowadays, tires are more expensive. If there is only a small crack, it can be corrected and a lot of money can be saved. However, if there is a big crack and for the sake of safety, it is better to replace it with a new one. So, how does the mender answer it?
As for the repairman, if he has no experience in repairing for the first time, he will first use the waste tire for trial repair. When repairing the full-automatic charging mixer tire, he often checks whether the tire repair machine temperature is normal and whether the air bag pressure is normal. Wear protective glasses when using the grinder; hold the grinder tightly and hit gently to avoid rebound. The following is the detailed steps of tire repair for the full-automatic feeding mixer, which we can refer to:
First, brush glue, wait for glue to dry in the shade, paste rubber and cord fabric inside the tire, and then compact and compact it to avoid air entrapment. Next, use the tire repair air bag which is the same as the tire size. It is necessary to suture the external trauma of the tire, and fill the tire with raw rubber after stitching. It should be noted that the raw rubber filling is 2-3 mm higher than the tread. The next step is to use the tire expander to open the tire. After the airbag is loaded into the braided belt or coated with talcum powder, the tire is loaded into the upper mold, and the iron sheet is placed in the center of the upper mold and the lower mold, and the rubber plate is placed above the air bag (cheap), and then the iron plate for maintaining the air bag is put in, and the lead screw is installed. Tighten the two lead screws, and make the tire quickly. Try to ensure that the tire fits tightly with the mold. If it does not fit, please loosen the lead screw and iron and adjust from the beginning. Finally, the remaining vulcanized rubber is cut off to ensure the smooth tread of automatic feeding mixer.
In a word, for the tires of full-automatic charging mixer, we not only need to clarify the causes of tire wear, but also select appropriate measures to manage them according to the actual production situation, and properly repair the tires when they are seriously damaged, so as to continuously reduce the impact of various factors on the tires, and then improve the efficiency of vehicle operation.